2021 Vintage – Merlot

So begins year 7 of winemaking! I recently moved into a house, so I have much more space to work and store things. So I’m looking to level up this year. Specifically, I want to own more equipment and not rent, and I’m going to try to age in oak barrels, not steel. And since I’m increasing the quality of my work, I want a high quality grape. So I’m going back to Thatcher Bay to get their Merlot, which I think I can say has produced the best wine so far!

September 20, 2021
The grapes arrived a week or two earlier than they have with previous years. I got the call ~4 days prior saying the grapes would be ready today. So I showed up with my dad at 7:30am. Scott had 983 pounds of Merlot in a bin that we moved by hand into my storage containers. This resulted in 13 full bins, and 2 half bins, so 70 pounds fit in each bin. I fit all but 3 full bins in my car and my dad transported the rest. It took just over an hour to fully pack all the containers. I could have fit one maybe two more bins in my car, but perhaps not all three. I left with an empty half bin and two empty buckets. I wanted to fill those up too, but Scott didn’t have it ready so I left.

The day before, I drove out to Brentwood to get a Crusher/Destemmer. These weren’t super easy to find. This particular one was manual (boo), but included a chute stand (yay). I set it up in the driveway right by the containers, and my dad, Rich and I went to work. There was a learning curve to get it working efficiently, but we got it down quickly. Here is the process: Rest a container on top of the hopper on its side to slowly drop the grapes to the entry point. Spin the handle to crush and destem. Collect the crushed grapes from the chute while clearing it manually since it gets a little backed up. Also, hand pick out some stems that come through. Twice a container-load or so, open the destemming area and manually remove stems that get stuck in there. Empty buckets into the large fermentor. Hose down ground periodically to prevent staining. That’s it! We started at 10:30 and finished around 1. Cleaning was ok. I took out the blade and hosed down that with the destemmer (in the street!). I think I was able to get 97% of all the stuff of it with a hose. I dosed it with 1.25 tsp per bin right after targeting 30ppm. And I cleaned the containers later that evening with a hose and think I did a great job (I don’t want them to be sticky at all!).

I went to MoreBeer that afternoon and got the yeast. I wanted BDX like I had in 2018 with that Merlot. But apparently it’s been renamed Bordeaux Red (lame name!). I got some yeast nutrients, and malolactic bacteria.

Grape Stats
983 pounds
24 Brix (probably accurate to +/- .5B)
pH 3.55 (according to Scott)
TA .4 (according to Scott)
1.25 tsp SO2 per bin targetting 30ppm.

September 21 – Day 1 Yeast pitched around 3pm
September 22 – Day 2
September 23 – Day 3 Brix 20 – added .5oz Fermaid K to each 3 fermentors
September 24 – Day 4 Brix 16
September 25 – Day 5 Brix 12
September 26 – Day 6 Brix 9 – added .5oz Fermaid K to each 3 fermentors
September 27 – Day 7 Brix 6
September 28 – Day 7 Brix 2
September 29 – Day 8 Brix 1
September 30 – Day 9 Brix 0
October 1 – Day 10 Brix -1 – I added malolactic bacteria to fermentors ~24 hours before pressing

October 2, 2021 – Press Day
We pressed today. I’ve been looking to purchase a press for a few weeks no, to no avail. I thought it would be easy to scoop one of these up on the used market, but it wasn’t. Further, even the stores didn’t have what I wanted for sale new! In years past, I’ve rented a #40 with a 18.5 gallon basket. And I could do a whole fermentor in one of these, meaning I had to do 3 loads. This year, I rented a #30 with a 8 gallon basket. And just as the math would say, I did juuust over 2 loads per fermentor; I think I did 7 loads total. It was somewhat more cumbersome to do more loads, packing, unpacking, disposing, etc. But there were some benefits. Notably, it’s short enough that it will fit in the perfect spot in my garage; this is really the most important factor. Secondarily, moving it around is just so much easier. Fitting it in my car, as well. It was also sooooo much easier to do this at my house, rather than the apartment. I didn’t have to lug all the equipment up/down stairs.
There was a hose ready. One downside to the event, we overflowed some kegs and the wine kinda stained the concrete in the backyard. I hope time will fade it away. We carried all the kegs back into the garage and dumped the pomace into the green bin (which was fully taken away by the garbage truck the next day, another big win). I’m left with 4 kegs, 1 one gallon jug and 3 half gallon jugs. I’m sure those jugs will be very useful for lees replacement, and maybe topping off down the line ….

#1 Free Run
#2 Free Run
#3 Free Run
#4 Press Run

October 4, 2021 – Apple Press Day
Colin is making apple with again this year. He brought over apples again a couple days ago for press day. And he used the apple crusher I got him a couple years ago. I was focused on the wine, but I know he crushed the apples, added water, and added sugar. He also added some enzymes? chemicals? tannins? I’m not sure. He had TODO lbs of apples. I added yeast ~24 hours later. And we pressed it Monday morning in two loads. Since it was still fermenting, I couldn’t fill a keg to the brim. I filled it close to the top, and there’s another carboy of ~2 gallon. I’ll bet I have 1 keg plus 1 gallon of apple wine, likely enough for lees replacement.